Installation manual
CNC 8035
PLC PROGRAMMING EXAMPLE
Definition of symbols (mnemonics)
13.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·411·
Used in: Coolant treatment.
Used in: Spindle turning control.
Used in: Treatment of the spindle gear change.
Used in: Keyboard simulation.
DEF I-COOLMA I82 The operator control the coolant. Manual mode.
DEF I-COOLAU I83 The CNC controls the coolant. Automatic mode.
DEF O-COOL O3 Coolant output
DEF O-S-ENAB O4 Spindle enable output
DEF O-GEAR1 O5 Move gears to select range 1 (gear 1)
DEF O-GEAR2 O6 Move gears to select range 2 (gear 1)
DEF I-GEAR1 I84 Indicates that Gear 1 is selected
DEF I-GEAR2 I85 Indicates that Gear 2 is selected
DEF I-SIMULA I86 The operator requests the simulation of program P12
DEF SENDKEY M1100 Indicates that the code of a key is to be sent out to the CNC
DEF KEYCODE R55 Indicates the code of the key to be simulated
DEF LASTKEY R56 Indicates which is the last key accepted by the CNC
DEF SENTOK M1101 Indicates that the key code has been sent correctly
DEF KEYBOARD R57 Used to indicate to the CNC the source of the keys
DEF CNCKEY 0 Used to indicate that the keys come from the CNC keyboard
DEF PLCKEY 1 Used to indicate that the keys come from the PLC
DEF MAINMENU $FFF4 Code of the "MAIN MENU" key
DEF SIMULATE $FC01 Code of the "SIMULATE" key (F2)
DEF KEY1 $31 Code of the "1" key
DEF KEY2 $32 Code of the "2" key
DEF ENTER $0D Code of the "ENTER" key
DEF THEOPATH $FC00 Code of the "THEORETICAL PATH" key (F1)
DEF START $FFF1 Code of the "START" key
To Next Page
Loading...
