Installation manual
CNC 8035
APPENDIX
CNC technical characteristics
A.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·425·
CNC TECHNICAL CHARACTERISTICS
General characteristics
3 feedback inputs for the axes.
3 analog outputs to control the axes (±10 V).
1 feedback input for the spindle encoder.
1 analog output to control the spindle (±10 V).
2 feedback inputs for the electronic handwheels.
2 inputs for digital probe (TTL or 24 V DC).
Digital CAN servo.
0.0001mm or 0.00001 inch resolution.
Multiplying factor up to x 25 with sinewave input.
Feedrate from 0.0001 to 99999.9999 mm/min (0.00001 - 3937 inches/min).
Maximum travel: ±99999.9999 mm (±3937 inches).
1 RS232C communication line.
40 optocoupled digital inputs
24 optocoupled digital outputs
32-bit processor
Math coprocessor
Graphics coprocessor.
256 Kb CNC program memory.
Block processing time of 6.5 ms.
Configurable sample time: 4, 5 or 6 ms
Approximate weight 7.5 Kg.
Maximum consumption of 48 W in normal operation.
Color monitor
Technology: Color TFT LCD.
Diagonal display area dimension: 10,4”.
Resolution: VGA 3 x 640 x 480 pixels.
Number of colors: 262144 Colors (6 bit for each subpixel RGB).
Backlit with 2 cold-cathode fluorescent lamps.
The machine manufacturer must comply with the EN 60204-1 (IEC-204-1) standard
in terms of protection against electrical shock due to faulty contacts with external
power supply.
This unit MUST NOT be opened by unauthorized personnel.
To avoid overheating the internal circuitry, do not block the ventilation grooves and
install a ventilation system that removes the hot air from the enclosure.
Due to the current state of the COLOR TFT LCD technology, all manufacturers accept
the fact the LCD screens have a certain number of defective pixels.
To Next Page
Loading...
