Installation manual
CNC 8035
APPENDIX
Summary of PLC commands
D.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·439·
Sequence breaking action instructions.
Arithmetic action instructions.
Logic action instructions.
= JMP L 1/256 Unconditional jump.
= RET Return or End of a subroutine.
= CAL L 1/256 Call to a subroutine.
= MOV Transfers the logic states of the indicated source to the indicated destination.
= NGU Complements all register bits.
= NGS Changes the sign of the Register contents.
= ADS Adds the contents of a two registers or a number and a register content.
= SBS Subtracts between the contents of two registers or between a number and a
register content.
= MLS Multiplies the contents of two registers or a number and a register content.
= DVS Divides the contents of two registers or a number and a register content.
= MDS Module between registers contents or between a number and a register content.
Origin Destination Source code Destination
code
Number of bits
to transmit
MOV I 1/512
O 1/512
M 1/5957
T 1/256
C 1/256
R 1/559
#
I 1/512
O 1/512
M 1/5957
R 1/559
0 (Bin)
1 (BCD)
0 (Bin)
1 (BCD)
32
28
24
20
16
12
8
4
ADS
SBS
MLS
DVS
MDS
R1/559
#
R1/559
#
R1/559
= AND Logic AND operation between register contents or between a number and a
register content.
= OR Logic OR operation between register contents or between a number and a
register content.
= XOR Logic XOR operation between register contents or between a number and a
register content.
= RR 1/2 Clockwise register rotation.
= RR 1/2 Counterclockwise register rotation.
AND
OR
XOR
R1/559
#
R1/559
#
R1/559
Origin Number of repetitions Destination
RR1
RR2
RL1
RL2
R1/559 R1/559
0/31
R1/559
To Next Page
Loading...
