Installation manual
CNC 8035
CNC CONFIGURATION
CNC structure
1.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·53·
"USB" port USB hard disk (Pen Drive) connection.
The USB 1.1 port admits connecting a "Pen Drive" type memory device. These memory devices
are commercially available (off-the-shelf) and they're all valid regardless of their size, brand name
or model.
This port is located in the top rear of the CNC.
The CNC recognizes this device as USB Hard Disk. Even if the CNC is turned on, when the USB
device is either inserted or extracted, it will be recognized immediately. When it is connected, it will
be shown as <USB hard disk> on the left panel of the <explorer>. To see its contents, press the
<update> (refresh) softkey.
Within the USB device, the CNC will only recognize files with extensions *fgr (software version), *fpg
(FPGA files) and part-programs. The CNC will not recognize any other type of file. Check it by
selecting <USB hard disk> on the left panel of the explorer. The right panel only shows the files stored
with the extensions mentioned earlier.
Only software versions can be transferred to the CNC's hard disk (KeyCF) through this USB device.
It can also be transferred from the USB to the hard disk (KeyCF).
WARNING:Part-programs cannot be edited or executed from the USB hard disk.
To install a new software version stored in the USB hard disk, first copy the *fgr file into the hard
disk (KeyCF).
Once the software version has been copied into the KeyCF, the transferred version may be installed.
This is done using the tools of the <explorer>. See the section "Loading the version from the hard
disk" in the 8035 CNC manual.
WARNING:A new software version cannot be installed directly from the USB hard disk.
+24V
0V
X9 X11X10 X12
X2 X3 X4 X5 X6
X8
X7
X1
B
A
C
D
E
Do not connect a multi-hub USB adapter to connect several devices at the same time.
It will only recognize the first Pen Drive that is connected. Nor will it recognize other
types of devices such as keyboards, mice, recorders, etc.
When using a USB cable, it should not be more than 3 m long.
From versions V11.1x and V12.1x on, the CNC will manage the hard disk (KeyCF)
and the USB hard disk at the same time.
To Next Page
Loading...
