Fagor 8035-T - General Machine Parameters

 Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·78·
4.2 General machine parameters
AXIS1 (P0) AXIS2 (P1) AXIS3 (P2) AXIS4 (P3)
AXIS5 (P4) AXIS6 (P5) AXIS7 (P6) AXIS8 (P7)
They permit associating axes, handwheels, spindles or live tools with each feedback input and
analog output according to the following code:
The following table shows the feedback input, the velocity command output and the default values
associated with each parameter.
About the handwheels
Depending on their configuration, the available handwheels are:
• General handwheel.
It can be used to jog any axis one by one. Select the axis and turn the handwheel to move it.
• Individual handwheel.
It replaces the mechanical handwheels. Up to 2 handwheels can be used (one per axis). It only
moves the axis it is associated with.
When using a Fagor 100P handwheel, no other handwheels may be used and it must be connected
as first handwheel. See "5.3 Movement with an electronic handwheel" on page 190.
Value Meaning Value Meaning
0 Free; not associated. 12 Handwheel with axis selector
button
1X axis. 13
2Y axis. 14
3Z axis. 21 Handwheel associated with X.
4U axis. 22 Handwheel associated with Y.
5V axis. 23 Handwheel associated with Z.
6W axis. 24 Handwheel associated with U.
7A axis. 25 Handwheel associated with V.
8B axis. 26 Handwheel associated with W.
9"C" axis. 27 Handwheel associated with A.
10 Main spindle. 28 Handwheel associated with B.
11 Handwheel. 29 Handwheel associated with C.
Parameter Feedback Command Default value
(connector) - M - - T -
AXIS1 (P0) 1st axis X10 X8 - Pin 2 1 (X axis) 1 (X axis)
AXIS2 (P1) 2nd axis X11 X8 - Pin 3 2 (Y axis) 3 (Z axis)
AXIS3 (P2) 3rd axis X12 X8 - Pin 4 3 (Z axis) 0 (free)
AXIS4 (P3) Not being
used
---- ---- 0 (free) 0 (free)
AXIS5 (P4) Spindle X4 X4 - Pins 10 and
12
10 (spindle) 10 (spindle)
AXIS6 (P5) 1st
handwheel
X5 ---- 11
(handwheel)
11
(handwheel)
AXIS7 (P6) 2nd
handwheel
X5 ---- 0 (free) 0 (free)
AXIS8 (P7) Not being
used
---- ---- 0 (free) 0 (free)