Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·80·
ISYSTEM (P13)
Indicates which function: G90 (absolute programming) or G91 (incremental programming) is
assumed on power-up, after executing M02,M30, EMERGENCY or RESET.
IFEED (P14)
Indicates which function: G94 (feedrate in mm/min or inch/min) or G95 (mm/rev or inch/rev)
is assumed on power-up, after executing M02,M30, EMERGENCY or RESET.
THEODPLY (P15)
Indicates whether the CNC will display real or theoretical position values according to the following
code:
GRAPHICS (P16)
On the T model, it indicates the axes coordinates system to be used for the graphic representation.
In this model, it also defines the layout of the keys of the X-Z axis on the jog keypad; on vertical lathes,
the X axis keys are swapped with those of the Z axis and vice versa.
Value Meaning
0 G90 (absolute programming).
1 G91 (incremental programming).
Default value: 0
Value Meaning
0 G94 (mm/min or inches/min).
1 G95 (mm/rev or inches/rev).
Default value: 0
Value Meaning
0 Real position values.
1 Theoretical position values.
Default value: 1
Possible values
Integer numbers between 0, 1, 2, 3.
Default value: 0
GRAPHICS = 0 GRAPHICS = 1 GRAPHICS = 2
GRAPHICS = 3
To Next Page
Loading...
