Installation manual
CNC 8035
MACHINE PARAMETERS
General machine parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·81·
On the M model, it indicates the axis system being used for the graphic representation as well as
the motion possibilities for the W axis added to those of the Z axis in the graphic representation (W
additive).
The ·4· value is only available when having PowerPC.
RAPIDOVR (P17)
Indicates whether it is possible to vary the feedrate override between 0% and 100% when working
in G00.
The feedrate override % may be changed from the operator panel switch, from the PLC, via DNC
or by program.
The feedrate % can always be changed in JOG movements.
MAXFOVR (P18)
Indicates the maximum value of the feedrate override % applicable to the programmed feedrate.
From the operator panel switch, it may be varied between 0% and 120% and from the PLC, DNC
or by program between 0% and 255%.
CIRINLIM (P19)
Indicates the maximum angular feedrate value for circular interpolations.
This limitation prevents circular interpolations resulting in polygons instead of arcs when the radius
is very small. The CNC adjusts the angular feedrate in order not to exceed the selected maximum
angular feedrate.
Value Meaning
0 Mill graphics.
1 Mill graphics with added W axis.
2 Boring Mill graphics.
3 Boring Mill graphics with added W axis.
4 Mill graphics (changed line graphics).
Default value: 0
GRAPHICS = 0 GRAPHICS = 4
Value Meaning
YES It may be modified.
NO It cannot be modified; it is set to 100 %.
Default value: NO
Possible values
Integer numbers between 0 and 255.
Default value: 120
Possible values
Integer numbers between 0 and 65535.
Default value: 0 (it is not limited)
To Next Page
Loading...
