·108·
Programming manual
CNC 8055
CNC 8055i
6.
PATH CONTROL
·M· & ·EN· MODELS
SOFT: V02.2X
G145. Temporary cancellation of tangential control
6.17 G145. Temporary cancellation of tangential control
Function G145 may be used to cancel the tangential control (G415) temporarily:
G145 K0
It cancels the tangential control temporarily. Function G45 stays in the history and the new function
G145 comes up in it.
If no G45 has been programmed, G145 is ignored. If K is not programmed, K0 will be assumed.
G145 K1
It resumes the tangential control of the axis with the angle it had before it was canceled. Then, G145
disappears from history.
To Next Page
Loading...
