Programming manual
CNC 8055
CNC 8055i
ADDITIONAL PREPARATORY FUNCTIONS
7.
·M· & ·EN· MODELS
SOFT: V02.2X
·113·
Working with square (G07) and round (G05,G50) corners
7.3 Working with square (G07) and round (G05,G50) corners
7.3.1 G07 (square corner)
When working in G07 (square corner) the CNC does not start executing the following program block
until the position programmed in the current block has been reached.
The CNC considers that the programmed position has been reached when the axis is within the
"INPOSW" (in-position zone or dead band) from the programmed position.
The theoretical and real profile coincide, obtaining square corners, as seen in the figure.
Function G07 is modal and incompatible with G05, G50 and G51. Function G07 can be programmed
as G7.
On power-up, after executing M02, M30 or after EMERGENCY or RESET, the CNC assumes code
G05 or G07 depending on how the general machine parameter "ICORNER" is set.
To Next Page
Loading...
