Fagor 8055 M - Look-Ahead Operation with Fagor Filters Active

Programming manual
CNC 8055
CNC 8055i
ADDITIONAL PREPARATORY FUNCTIONS
7.
·M· & ·EN· MODELS
SOFT: V02.2X
·119·
Look-ahead (G51)
7.4.2 Look-ahead operation with Fagor filters active
This option makes it possible to use Fagor filters with Look-ahead (not advanced look-ahead
algorithm). It will only be considered if the advanced look-ahead algorithm is deactivated; that is,
if bit 15 of g.m.p. LOOKATYP (P160)=0.
To activate/deactivate this option, use bit 13 of g.m.p. LOOKATYP (P160).
Effect of Fagor filters when machining circles
When machining circles, the error will be smaller when using Fagor filters than without using these
filters:
Programmed movement.
Real (actual) movement using Fagor filters.
Real (actual) movement without using Fagor filters.