Programming manual
CNC 8055
CNC 8055i
CANNED CYCLES
9.
·M· & ·EN· MODELS
SOFT: V02.2X
·183·
G87. Rectangular pocket canned cycle.
[ I±5.5 ] Machining depth.
Defines the machining depth.
When programmed in absolute coordinates, it will be referred to the part zero and when programmed
in incremental coordinates, it will be referred to the starting plane (P.P.).
[ J±5.5 ] Half the width of the pocket along the abscissa axis
Defines the distance from the center to the edge of the pocket according to the abscissa axis. The
sign indicates the pocket machining direction.
[ K5.5 ] Half the width of the pocket along the ordinate axis
Defines the distance from the center to the edge of the pocket according to the ordinate axis.
[ B±5.5 ] Penetration step
Defines the cutting depth according to the longitudinal axis.
If this is programmed with a positive sign, the entire cycle will be executed with the same machining
pass, this being equal to or less than that programmed.
If programmed with a negative sign, the whole pocket is machined with the given pass (step) except
the last pass that machines the rest.
[ C±5.5 ] Milling pass
Defines the milling pass along the main plane.
If the value is positive, the entire cycle will be executed with the same milling step, this being equal
to or less than that programmed.
If the value is negative, the entire pocket will be executed with the given step, except for the last step
which will machine whatever remains.
If not programmed, it assumes a value of 3/4 of the diameter of the selected tool.
J with "+" sign J with "-" sign
To Next Page
Loading...
