Programming manual
CNC 8055
CNC 8055i
CANNED CYCLES
9.
·M· & ·EN· MODELS
SOFT: V02.2X
·189·
G88. Circular pocket canned cycle
[ J±5.5 ] Pocket radius
Defines the radius of the pocket. The sign indicates the pocket machining direction.
[ B±5.5 ] Penetration step
Defines the cutting pass along the longitudinal axis to the main plane.
• If this value is positive, the entire cycle will be executed with the same machining pass, this being
equal to or less than that programmed.
• If the value is negative, the entire pocket will be executed with the given step, except for the last
step which will machine whatever remains.
[ C±5.5 ] Milling pass
Defines the milling pass along the main plane.
• If the value is positive, the entire cycle will be executed with the same milling step, this being
equal to or less than that programmed.
• If the value is negative, the entire pocket will be executed with the given step, except for the last
step which will machine whatever remains.
If not programmed, it assumes a value of 3/4 of the diameter of the selected tool.
If programmed with a value greater than the tool diameter, the CNC issues the relevant error
message.
If programmed with a 0 value, the CNC will display the corresponding error message.
J with "+" sign J with "-" sign
To Next Page
Loading...
