Programming manual
CNC 8055
CNC 8055i
CANNED CYCLES
9.
·M· & ·EN· MODELS
SOFT: V02.2X
·197·
G210. Bore milling canned cycle
The tool must meet the following conditions:
• The tool radius must be smaller than J/2.
• The tool radius must be equal to or larger than (J-K)/4.
If these two conditions are not met, the CNC issues the corresponding error.
[ B±5.5 ] Penetration step
It defines the penetration step when machining the hole.
• With a positive sign, it will mill the bottom of the hole.
• With a negative sign, it will not mill the bottom of the hole.
If not programmed or programmed with a 0 value, the CNC will display the corresponding error
message.
To Next Page
Loading...
