Programming manual
CNC 8055
CNC 8055i
MULTIPLE MACHINING
10.
·M· & ·EN· MODELS
SOFT: V02.2X
·215·
G63: Multiple machining in a circular pattern
[ P Q R S T U V ] Points where no drilling takes place
These parameters are optional and are used to indicate at which points or between which of those
programmed points it is not required to machine.
Thus, programming P7 indicates that it is not required to do machining at point 7, and programming
Q10.013 indicates that machining is not required from point 10 to 13, or expressed in another way,
that no machining is required at points 10, 11, 12 and 13.
When it is required to define a group of points (Q10.013), care should be taken to define the final
point with three digits, as if Q10.13 is programmed, multiple machining understands Q10.130.
The programming order for these parameters is P Q R S T U V, it also being necessary to maintain
the order in which the points assigned to these are numbered, i.e., the numbering order of the points
assigned to Q must be greater than that assigned to P and less than that assigned to R.
Example:
Proper programming P5.006 Q12.015 R20.022
Correct programming P5.006 Q12.015 R20.022
If these parameters are not programmed, the CNC understands that it must perform machining at
all the points along the programmed path.
To Next Page
Loading...
