Programming manual
CNC 8055
CNC 8055i
IRREGULAR POCKET CANNED CYCLE
11.
·M· & ·EN· MODELS
SOFT: V02.2X
·241·
2D pockets
11.1.7 Errors
The CNC will issue the following errors:
ERROR 1023 G67. Tool radius too large.
When selecting a wrong roughing tool.
ERROR 1024 G68. Tool radius too large.
When selecting a wrong finishing tool.
ERROR 1025 A tool with no radius has been programmed
When using a tool with "0" radius while machining a pocket.
ERROR 1026 A step has been programmed that is larger than the tool diameter
When parameter "C" of the roughing operation is greater than the diameter of the roughing tool.
ERROR 1041 A parameter required in the canned cycle has not been programmed.
It comes up in the following instances:
• When parameters "I" and "R" have not been programmed in the roughing operation.
• When not using a roughing operation and not programming the "I" and "R" parameters for the
finishing operation.
ERROR 1042 Wrong parameter value in the canned cycle
It comes up in the following instances:
• When parameter "Q" of the finishing operation has the wrong value.
• When parameter "B" of the finishing operation has a "0" value.
• When parameter "J" of the finishing operation has been programmed with a value greater than
the finishing tool radius.
ERROR 1044 The plane profile intersects itself in an irregular pocket with islands.
It comes up when any of the plane profiles of the programmed contours intersects itself.
ERROR 1046 Wrong tool position prior to the canned cycle
It comes up when calling the G66 cycle if the tool is positioned between the reference plane and
the depth coordinate (bottom) of any of the operations.
ERROR 1047 Open plane profile in an irregular pocket with islands
It comes up when any of the programmed contours does not begin and end at the same point. It
may be because G1 has not been programmed after the beginning, with G0, on any of the profiles.
ERROR 1048 Part surface coordinate not programmed in pocket with islands
It comes up when the first point of the geometry does not include the pocket top coordinate.
ERROR 1049 Wrong reference plane coordinate for the canned cycle.
It comes up when the coordinate of the reference plane is located between the part's "top" and
"bottom" in any of the operations.
ERROR 1084 Arc programmed wrong’
It comes up when any of the paths programmed in the geometry definition of the pocket is wrong.
To Next Page
Loading...
