Programming manual
CNC 8055
CNC 8055i
IRREGULAR POCKET CANNED CYCLE
11.
·M· & ·EN· MODELS
SOFT: V02.2X
·251·
3D pockets
• If programmed with a negative sign, all the roughing will be performed with the programmed
pass, and the canned cycle will adjust the last pass to obtain the total programmed depth.
If done with B(+), the ridges will appear only on the pocket walls; but, if done with B(-), they could
also show up above the islands.
[ C5.5 ] Milling pass
Defines the milling pass in roughing along the main plane, the entire pocket being performed with
the given pass, and the canned cycle adjusts the last milling pass.
If not programmed or programmed with a 0 value, it assumes a value of 3/4 of the diameter of the
selected tool.
If programmed with a value greater than the tool diameter, the CNC issues the relevant error
message.
[ I±5.5 ] Pocket depth
Defines the total depth of the pocket and is programmed in absolute coordinates. It must be
programmed.
[ R±5.5 ] Reference plane
Defines the reference plane coordinate and is programmed in absolute coordinates. It must be
programmed.
[ V5.5 ] Penetration feedrate
Defines the tool penetrating feedrate.
If not programmed or programmed with a 0 value, it assumes 50% of the feedrate in the plane (F).
[ F5.5 ] Machining feedrate
Optional. It sets the machining feedrate in the plane.
[ S5.5 ] Spindle speed
Optional. It sets the spindle speed.
To Next Page
Loading...
