·252·
Programming manual
CNC 8055
CNC 8055i
11.
IRREGULAR POCKET CANNED CYCLE
·M· & ·EN· MODELS
SOFT: V02.2X
3D pockets
[ T4 ] Tool number
Defines the tool used for the roughing operation. It must be programmed.
[ D4 ] Tool offset
Optional. Defines the tool offset number.
[ M ] Auxiliary (miscellaneous) functions
Optional. Up to 7 miscellaneous M functions can be programmed.
This operation allows M06 with an associated subroutine to be defined, and the tool change is
performed before beginning the roughing operation.
To Next Page
Loading...
