·260·
Programming manual
CNC 8055
CNC 8055i
11.
IRREGULAR POCKET CANNED CYCLE
·M· & ·EN· MODELS
SOFT: V02.2X
3D pockets
4. The depth profile must be defined after having defined the plane profile.
The beginning points of the plane profile and depth profile must be the same one.
Nevertheless, the depth profile must be programmed:
For the outside contour of the pocket starting from the top or surface coordinate (1).
For the inside contours, islands, starting from the bottom or base coordinate (2).
5. The depth profile must be open and without direction changes along its path. In other words,
it cannot zig-zag.
The following examples cause a geometry error.
To Next Page
Loading...
