Programming manual
CNC 8055
CNC 8055i
IRREGULAR POCKET CANNED CYCLE
11.
·M· & ·EN· MODELS
SOFT: V02.2X
·267·
3D pockets
11.2.7 Profile stacking
When 2 or more profiles stack on top of each other, the following considerations must be taken into
account.
The base coordinate of the top profile (2) must coincide with the surface coordinate of the bottom
profile (1).
If there is a gap between them, the cycle will consider that they are 2 different profiles and it will
eliminate the top profile when executing the bottom one.
If the profiles mix, the canned cycle will make a groove around the top profile when running the
finishing pass.
For clarity sakes, refer to the drawing on the right
that consists of 2 stacked profiles: 1 and 2.
To Next Page
Loading...
