Programming manual
CNC 8055
CNC 8055i
IRREGULAR POCKET CANNED CYCLE
11.
·M· & ·EN· MODELS
SOFT: V02.2X
·269·
3D pockets
• Profiles are described as programmed paths, it being possible to include corner rounding,
chamfers, etc., following the syntax rules defined for this purpose.
• The profile description must not contain: mirror images, scaling factor changes, pattern rotation,
zero offsets, etc.
• It must not contain high level blocks such as jumps, calls to subroutines or parametric
programming.
• It must not contain other canned cycles.
In addition to the G00 function, which has a special meaning, the irregular pocket canned cycle
allows the use of the following functions for the definition of profiles.
G01 Linear interpolation.
G02 Clockwise circular interpolation.
G03 Counter-clockwise circular interpolation.
G06 Circle center in absolute coordinates.
G08 Arc tangent to previous path.
G09 Arc defined by three points.
G16 Main plane selection by two addresses and longitudinal axis.
G17 Main plane X-Y, and longitudinal axis Z.
G18 Main plane Z-X, and longitudinal axis Y.
G19 Main plane Y-Z, and longitudinal axis X.
G36 Corner rounding, radius blend.
G39 Chamfer.
G53 Programming with respect to machine zero.
G70 Programming in inches.
G71 Programming in millimeters.
G90 Absolute programming.
G91 Incremental programming.
G93 Polar origin preset.
To Next Page
Loading...
