CNC 8055
CNC 8055i
·M· & ·EN· MODELS
SOFT: V02.2X
1
·27·
GENERAL CONCEPTS
The CNC may be programmed at the machine (from the front panel) and from a peripheral
(computer). Memory available to the user for carrying out the part programs is 1 Mbyte.
The part programs and the values in the tables which the CNC has can be entered from the front
panel, from a pc (DNC) or from a peripheral.
Entering programs and tables from the front panel.
Once the editing mode or desired table has been selected, the CNC allows you to enter data from
the keyboard.
Entering programs and tables from a Computer (DNC) or peripheral device.
The CNC allows data to be exchanged with a computer or peripheral device, using the RS232C serial
line.
If this is controlled from the CNC, it is necessary to preset the corresponding table or part program
directory (utilities) you want to communicate with.
Depending on the type of communication required, the serial port machine parameter "PROTOCOL"
should be set.
"PROTOCOL" = 0 if the communication is with a peripheral device.
"PROTOCOL" = 1 if the communication is via DNC.
To Next Page
Loading...
