Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·295·
PROBE 1. Tool length calibrating canned cycle
12.3.3 Measure or calibrate the tool radius wear and tool length wear.
The type of operation (calibration or measurement) is selected when calling the cycle.
The programming format depends on the operation to carry out:
• Tool radius Calibration.
(PROBE 1, B, I3, F, J0, K, D, E, S, N, X, U, Y, V, Z, W)
• Radius wear measurement.
(PROBE 1, B, I3, F, J1, K, L, D, E, S, M, C, N, X, U, Y, V, Z, W)
[ B5.5 ] Safety distance
It must be programmed with a positive value greater than 0.
[ I ] Type of calibration or wear measurement
The calibration may be done on the tool shaft or on its tip.
I = 3 Measure or calibrate the tool radius wear and tool length wear.
If not programmed, the cycle will assume the IO value.
[ F5.5 ] Probing feedrate
It sets the probing feedrate. It must be programmed in mm/minute or inches/minute.
[ J ] Type of operation
J = 0 Tool calibration.
J = 1 Tool wear measurement.
[ K ] Probe side used
It sets the probe side being used to probe the radius.
K = 0 Side X+.
K = 1 Side X-.
K = 2 Side Y+.
K = 3 Side Y-.
[ L5.5 ] Maximum length wear allowed
When set to zero, the tool will not be rejected due to length wear. When the measured wear is greater
than the defined value, the tool will be rejected.
Only if J1 has been defined and tool life monitoring is being used. If not programmed, the canned
cycle will assume the L0 value.
[ D5.5 ] Distance from the tool shaft to the probing point
It sets the radius or distance referred to the tool shaft being probed.
If not defined, probing is carried out on the tool tip.
[ E5.5 ] Distance from the tool tip to the probing point.
Distance referred to the theoretical tool tip being probed.
This parameter may be very useful on tools with cutters whose bottom is not horizontal.
If not programmed, the cycle will assume the E0 value.
To Next Page
Loading...
