·296·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· MODELS
SOFT: V02.2X
PROBE 1. Tool length calibrating canned cycle
[ S±5.5 ] Speed and turning direction of the tool
To probe with the spindle running, the tool must be turning in the opposite direction to the cutting
direction.
• When set to 0, probing is carried out with the spindle stopped.
• When set with a positive value, the spindle starts in M3.
• When set with a negative value, the spindle starts in M4.
[ M5.5 ] Maximum radius wear allowed
When set to 0, the tool is not rejected due to radius wear. When the measured wear is greater than
the defined value, the tool will be rejected.
Only if J1 has been defined and tool life monitoring is being used. If not programmed, a value of
M0 will be assumed.
[ C ] Behavior when exceeding the amount of wear allowed
Only if "M" or "L" has been set to other than zero.
C = 0 It interrupts the execution for the user to select another tool.
C = 1 The cycle replaces the tool with another one of the same family.
If not programmed, the cycle will assume the C0 value.
[ N ] Number of edges to measure
When set to zero, it only takes one measurement. If not programmed, the cycle will assume the N0
value.
To measure each cutting edge when the spindle has feedback and s.m.p. M19TYPE (P43) =1.
[ X U Y V Z W ] Probe position
Optional parameters. See "Programming format" on page 289.
To Next Page
Loading...
