Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·299·
PROBE 2. Probe calibration canned cycle.
The programming format for this cycle is:
(PROBE 2, X, Y, Z, B, J, E, H, F)
[ X±5.5 ] Real coordinate, along the X axis, of the hole center.
[ Y±5.5 ] Real coordinate, along the Y axis, of the hole center.
[ Z±5.5 ] Real coordinate, along the Z axis, of the hole center.
[ B5.5 ] Safety distance
Defines the safety distance. Must be programmed with a positive value and over 0.
[ J5.5 ] Real diameter of the hole
Defines the real diameter of the hole. Must be programmed with a positive value and over 0.
[ E5.5 ] Withdrawal distance
Defines the distance which the probe moves back after initial probing. Must be programmed with
a positive value and over 0.
[ H5.5 ] Initial probing feedrate
Defines the feedrate for the initial probing movement. It must be programmed in mm/minute or
inches/minute.
[ F5.5 ] Probing feedrate
It sets the probing feedrate. It must be programmed in mm/minute or inches/minute.
To Next Page
Loading...
