Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·301·
PROBE 2. Probe calibration canned cycle.
·2· Movement along the longitudinal axis to the coordinate of the point (along this axis) from
where the cycle was called.
·3· Movement in the main work plane to the point where the cycle is called.
Correction of the tool offset.
Once the cycle has been completed, the CNC will have updated the "I" and "K" values corresponding
to the tool offset selected at the time on the tool offset table.
Arithmetic parameters modified by the cycle
The cycle returns in arithmetic parameter P299 the best value to be assigned to general machine
parameter PRODEL.
To Next Page
Loading...
