Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·303·
PROBE 3. Surface measuring canned cycle
[ D4 ] Tool offset
Defines the number of the tool offset to be corrected, once the measurement cycle is completed.
If this is not programmed or is programmed with a value of 0, the CNC will understand that it is not
required to make this correction.
[ L5.5 ] Error tolerance
Defines the tolerance that will be applied to the error measured. It will be programmed with an
absolute value and the tool offset will be corrected only when the error exceeds this value.
If this is not programmed, the canned cycle will take the value of 0.
To Next Page
Loading...
