Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·305·
PROBE 3. Surface measuring canned cycle
Correction of the tool offset.
If the Tool Offset Number (D) was selected, the CNC will modify the values of this tool offset,
whenever the measurement error is equal to or greater than the tolerance (L).
Depending on the axis the measurement is made with (K), the correction will be made on the length
or radius value.
• If the measurement is made with the axis longitudinal to the work plane, the length wear (K) of
the indicated tool offset (D) will be modified.
• If the measurement is made with one of the axes that make up the work plane, the radius wear
(I) of the indicated tool offset (D) will be modified.
To Next Page
Loading...
