Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·309·
PROBE 5. Inside corner measuring canned cycle.
12.7 PROBE 5. Inside corner measuring canned cycle.
A probe placed in the spindle will be used, which must be previously calibrated by means of canned
cycles:
Tool length calibrating canned cycle.
Probe calibrating canned cycle.
The programming format for this cycle is:
(PROBE 5, X, Y, Z, B, F)
[ X±5.5 ] Theoretical coordinate, along the X axis, of the corner to be measured
[ Y±5.5 ] Theoretical coordinate, along the Y axis, of the corner to be measured
[ Z±5.5 ] Theoretical coordinate, along the Z axis, of the corner to be measured
The probe must be placed within the pocket before calling the cycle.
[ B5.5 ] Safety distance
Defines the safety distance. Must be programmed with a positive value and over 0.
The probe must be placed, with respect to the point to be measured, at a distance greater than this
value when the cycle is called.
[ F5.5 ] Probing feedrate
It sets the probing feedrate. It must be programmed in mm/minute or inches/minute.
To Next Page
Loading...
