·312·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· MODELS
SOFT: V02.2X
PROBE 6. Angle measuring canned cycle
12.8 PROBE 6. Angle measuring canned cycle
A probe placed in the spindle will be used, which must be previously calibrated by means of canned
cycles:
Tool length calibrating canned cycle.
Probe calibrating canned cycle.
The programming format for this cycle is:
(PROBE 6, X, Y, Z, B, F)
[ X±5.5 ] Theoretical coordinate, along the X axis, of the vertex of the angle to be measured.
[ Y±5.5 ] Theoretical coordinate, along the Y axis, of the vertex of the angle to be measured
[ Z±5.5 ] Theoretical coordinate, along the Z axis, of the vertex of the angle to be measured.
[ B5.5 ] Safety distance
Defines the safety distance. Must be programmed with a positive value and over 0.
The probe must be placed, with respect to the point to be measured, at a distance greater than
double this value when the cycle is called.
[ F5.5 ] Probing feedrate
It sets the probing feedrate. It must be programmed in mm/minute or inches/minute.
To Next Page
Loading...
