·314·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· MODELS
SOFT: V02.2X
PROBE 6. Angle measuring canned cycle
Arithmetic parameters modified by the cycle
Once the cycle has been completed, the CNC will return the real values obtained after
measurement, in the following global arithmetic parameter.
Considerations for the cycle
This cycle may be used to measure angles between ±45º.
• If the angle to be measured is > 45º, the CNC will display the corresponding error.
• If the angle to be measured is < -45º, the probe will collide with the part.
P295 Inclination angle which the part has in relation to the abscissa axis.
To Next Page
Loading...
