Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· MODELS
SOFT: V02.2X
·315·
PROBE 7. Corner and angle measuring canned cycle.
12.9 PROBE 7. Corner and angle measuring canned cycle.
A probe placed in the spindle will be used, which must be previously calibrated by means of canned
cycles:
Tool length calibrating canned cycle.
Probe calibrating canned cycle.
The programming format for this cycle is:
(PROBE 7, K, X, Y, Z, B, F)
[ X±5.5 ] Theoretical coordinate, along the X axis, of the corner to be measured
[ Y±5.5 ] Theoretical coordinate, along the Y axis, of the corner to be measured
[ Z±5.5 ] Theoretical coordinate, along the Z axis, of the corner to be measured
If it is an outside corner, depending on the corner of the part it is required to measure, the probe
must be placed in the corresponding shaded area (see figure) before calling the cycle.
If it is an inside corner, the probe must be placed within the pocket before calling the cycle.
[ K ] Type of corner
Defines the type of corner to be measured:
K = 0: Measuring an outside corner.
K = 1: Measuring an inside corner.
[ B5.5 ] Safety distance
Defines the safety distance. Must be programmed with a positive value and over 0.
The probe must be placed, with respect to the point to be measured, at a distance greater than
double this value when the cycle is called.
[ F5.5 ] Probing feedrate
It sets the probing feedrate. It must be programmed in mm/minute or inches/minute.
To Next Page
Loading...
