·316·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· MODELS
SOFT: V02.2X
PROBE 7. Corner and angle measuring canned cycle.
12.9.1 Basic operation (measuring an outside corner)
1. Approach movement.
Movement of the probe in rapid (G00) from the point where the cycle is called to the first approach
point, situated at a distance (2B) from the first side to be probed.
The approaching movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis.
2. Probing movement.
Movement of the probe along the abscissa axis at the indicated feedrate (F), until the probe signal
is received.
The maximum distance to be traveled in the probing movement is 3B; if, after travelling that
distance, the CNC does not receive the probe signal, it will display the corresponding error code
and stop the movement of the axes.
3. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the first approach point.
4. Second approach movement.
Movement of the probe in rapid (G00) from the first approach point to the second, situated at
a distance (2B) from the second side to be probed.
The approaching movement is made in two stages:
·1· Movement along the ordinate plane.
·2· Movement along the abscissa axis.
5. Second probing movement.
Movement of the probe along the abscissa axis at the indicated feedrate (F), until the probe signal
is received.
The maximum distance to be traveled in the probing movement is 3B; if, after travelling that
distance, the CNC does not receive the probe signal, it will display the corresponding error code
and stop the movement of the axes.
6. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the second approach point.
7. Third approach movement.
Rapid probe move (G00) from the second approach point to the third. It is at a distance (B) from
the previous one.
8. Third probing movement.
Movement of the probe along the abscissa axis at the indicated feedrate (F), until the probe signal
is received.
The maximum distance to be traveled in the probing movement is 4B; if, after travelling that
distance, the CNC does not receive the probe signal, it will display the corresponding error code
and stop the movement of the axes.
To Next Page
Loading...
