Fagor 8055 M - Variables Associated with Coordinates

Programming manual
CNC 8055
CNC 8055i
HIGH-LEVEL LANGUAGE PROGRAMMING
13.
·M· & ·EN· MODELS
SOFT: V02.2X
·353·
Variables
13.2.8 Variables associated with coordinates
The coordinate values for each axis are given in the active units:
If G70, in inches (within ±3937.00787).
If G71, in millimeters (within ±99999.9999).
If rotary axis in degrees (within ±99999.9999).
Read-only variables
Accessing any of the variables POS(X-C), TPOS(X-C), APOS(X-C), ATPOS(X-C), DPOS(X-C),
FLWE(X-C), DEFLEX, DEFLEY or DEFLEZ interrupts block preparation and the CNC waits for that
command to be executed before resuming block preparation.
PPOS(X-C)
Returns the programmed theoretical coordinate of the selected axis.
POS(X-C)
It returns the real tool base position value referred to machine reference zero (home).
On limit-less rotary axes, this variable takes into account the value of the active zero offset. The
values of the variable are between the active zero offset and ±360º (ORG* ± 360º).
If ORG* = 20º it displays between 20º and 380º / displays between -340º and 20º.
If ORG* = -60º it displays between -60º and 300º / displays between -420 and -60º
TPOS(X-C)
It returns the theoretical position value (real coordinate + following error) of the tool base referred
to machine reference zero (home).
On limit-less rotary axes, this variable takes into account the value of the active zero offset. The
values of the variable are between the active zero offset and ±360º (ORG* ± 360º).
If ORG* = 20º it displays between 20º and 380º / displays between -340º and 20º.
If ORG* = -60º it displays between -60º and 300º / displays between -420 and -60º
APOS(X-C)
It returns the real tool base position value, referred to part zero, of the selected axis.
ATPOS(X-C)
It returns the theoretical position value (real coordinate + following error) of the tool base referred
to part zero.
DPOS(X-C)
The CNC updates this variable whenever probing operations G75, G76 and probing cycles PROBE
and DIGIT are carried out.
When the digital probe communicates with the CNC via infrared beams, there could be some delay
(milliseconds) from the time the probe touches the part to the instant the CNC receives the probe
signal.
(P110=PPOSX)
It assigns to P100 the programmed theoretical position of the X axis.