Programming manual
CNC 8055
CNC 8055i
COORDINATE TRANSFORMATION
15.
·M· & ·EN· MODELS
SOFT: V02.2X
·427·
Movement in an inclined plane
Then, it must be rotated around the Y' axis the R amount.
In the figure, the new coordinate system resulting from this transformation is called X'' Y' Z' because
the X, Z axes have been rotated.
And last, rotate around the Z' axis the amount indicated by S.
G49 X Y Z I J K R S
Defines the inclined plane specifying the angles forming the new inclined plane with the X Y and
Z axes of the machine's coordinate system.
X Y Z
Define the coordinate origin of the inclined plane.
Indicate the X, Y, Z coordinates with respect to the current coordinate origin.
I J K
They define the angles forming the new inclined plane with the X Y and Z axes of the machine's
coordinate system. Only two of these three angles are programmed.
To Next Page
Loading...
