Programming manual
CNC 8055
CNC 8055i
AXES AND COORDINATE SYSTEMS
3.
·M· & ·EN· MODELS
SOFT: V02.2X
·43·
Plane selection (G16, G17, G18, G19)
When radius compensation is done on the work plane, and length compensation on the
perpendicular axis, the CNC does not allow functions G17, G18, and G19 if any one of the X, Y,
or Z axes is not selected as being controlled by the CNC.
On power-up, after executing M02, M30 or after EMERGENCY or RESET, the CNC will assume that
the plane defined by the general machine parameter as "IPLANE" is the work plane.
Function G49, coordinate transformation, must be used to machine inclined planes.
See chapter "15 Coordinate transformation".
To Next Page
Loading...
