·434·
Programming manual
CNC 8055
CNC 8055i
15.
COORDINATE TRANSFORMATION
·M· & ·EN· MODELS
SOFT: V02.2X
Movement in an inclined plane
15.1.6 Parameters associated with function G49
Once G49 has been executed, the CNC updates global parameters P297 and P298:
P297 It indicates the position to be occupied by the spindle's main rotary axis in order to orient
the spindle perpendicular to the indicated inclined plane. It is the same value as shown
by the TOOROF variable.
P298 It indicates the position to be occupied by the spindle's secondary rotary axis in order
to orient the spindle perpendicular to the indicated inclined plane. It is the same value
as shown by the TOOROS variable.
These parameters are global. Therefore, they can be modified by the user or even by probing cycles
of the CNC itself.
They should be used after executing G49. Otherwise, variables TOOROF and TOOROS should be
used.
To Next Page
Loading...
