·436·
Programming manual
CNC 8055
CNC 8055i
15.
COORDINATE TRANSFORMATION
·M· & ·EN· MODELS
SOFT: V02.2X
Movement according to the tool coordinate system (G47)
15.2 Movement according to the tool coordinate system (G47)
When using this function, a swivel or angled spindle should be utilized (general machine parameter
"XFORM (P93)" set to 2 or 3).
When not using function G47, the tool moves according to the part coordinate system
Now, to move the tool according to the tool coordinate system, function G47 must be used when
programming the movement of the Z axis (G01 G47 Z).
The movements programmed with G47 are always incremental.
Function G47 is not modal and it only acts within the block (linear path) where it has been
programmed.
G47 can also be programmed while G48 and G49 are active.
In the example on the left, the part coordinates coincide with those of the machine and in
the example on the right, an inclined plane is active (G49).
To Next Page
Loading...
