Programming manual
CNC 8055
CNC 8055i
COORDINATE TRANSFORMATION
15.
·M· & ·EN· MODELS
SOFT: V02.2X
·441·
TCP Transformation (G48)
When working with inclined planes and TCP transformation, it is recommended to follow this
programming order (sequence):
G48 S1 Turn TCP transformation on.
G49 ... Define the inclined plane.
G01 AP298 BP297 Position the tool perpendicular to the plane.
G... Start machining.
... End of the machining operation.
G49 Cancel the inclined plane.
G48 S0 Turn TCP transformation off.
M30 End of part program.
RTCP should be turned on first because it allows orienting the tool without modifying the tool tip
position, thus avoiding undesired collisions.
To Next Page
Loading...
