·450·
Programming manual
CNC 8055
CNC 8055i
A.
·M· & ·EN· MODELS
SOFT: V02.2X
ISO code programming
M means modal, i.e. the G function, once programmed, remains active until another incompatible
G function is programmed or until an M02, M30, EMERGENCY or RESET is executed or the CNC
is turned off and back on.
D means BY DEFAULT, i.e. they will be assumed by the CNC when it is powered on, after executing
M02, M30 or after EMERGENCY or RESET.
In those cases indicated by ?, it should be understood that the DEFAULT of these G functions
depends on the setting of the general machine parameters of the CNC.
The letter V means that the G code is displayed next to the current machining conditions in the
execution and simulation modes.
G61 * Multiple machining in rectangular pattern 10.2
I* * Grid pattern canned cycle 10.3
G63 * Multiple machining in a circular pattern 10.4
G64 * Multiple machining in an arc 10.5
G65 * Machining programmed with an arc-chord 10.6
G66 * Irregular pocket canned cycle 11.1 / 11.2
G67 * Irregular pocket roughing 11.1.2
G68 * Irregular pocket finishing 11.1.3
G69 * * Drilling canned cycle with variable peck 9.6
G70 * ? * Programming in inches 3.3
G71 * ? Programming in millimeters 3.3
G72 * * General and specific scaling factor 7.6
G73 * * Rotation of the coordinate system 7.7
G74 * Machine reference (home) search 4.2
G75 * Probing move until touching 12.1
G76 * Probing move while touching 12.1
G77 * * Axis coupling (slaving) 7.8.1
G77S * * Spindle synchronization 5.5
G78 * * Cancellation of axis coupling (slaving) 7.8.2
G78S * * Cancellation of spindle synchronization 5.5
G79 Canned cycle parameter modification 9.2.1
G80 * * Canned cycle cancellation 9.3
G81 * * Drilling canned cycle 9.7
G82 * * Drilling canned cycle with dwell 9.8
G83 * * Deep-hole drilling canned cycle with constant peck 9.9
G84 * * Tapping canned cycle 9.10
G85 * * Reaming canned cycle 9.11
G86 * * Boring canned cycle with withdrawal in G00 9.12
G87 * * Rectangular pocket canned cycle. 9.13
G88 * * Circular pocket canned cycle 9.14
G89 * * Boring canned cycle with withdrawal in G01 9.15
G90 * ? Absolute programming: 3.4
G91 * ? * Incremental programming 3.4
G92 Coordinate preset / spindle speed limit 4.4.1
G93 Polar origin preset 4.5
G94 * ? Feedrate in millimeters (inches) per minute 5.2.1
G95 * ? * Feedrate in millimeters (inches) per revolution. 5.2.2
G96 * * Constant cutting point speed 5.2.3
G97 * * Constant tool center speed 5.2.4
G98 * * Withdrawal to the starting plane at the end of the canned cycle 9.5
G99 * * Withdrawal to the reference plane at the end of the canned cycle 9.5
G145 * * Temporary cancellation of tangential control 6.17
Function M D V Meaning Section
To Next Page
Loading...
