Fagor 8055 M - C. Summary of internal CNC variables.

Programming manual
CNC 8055
CNC 8055i
C.
·M· & ·EN· MODELS
SOFT: V02.2X
·455·
Summary of internal CNC variables.
SUMMARY OF INTERNAL CNC VARIABLES.
• The R symbol indicates that the variable can be read.
• The W symbol indicates that the variable can be modified.
Variables associated with tools.
Variables associated with zero offsets.
Variables associated with function G49
Variables associated with the definition of function G49.
Variable CNC PLC DNC
( section 13.2.2 )
TOOL R R R Number of the active tool.
TOD R R R Number of active tool offset.
NXTOOL R R R Number of the next requested tool waiting for M06.
NXTOD R R R Number of the next tool’s offset.
TMZPn R R - (n) tool’s position in the tool magazine.
PTOOL R - - Magazine position to leave the current tool.
PNXTOOL R - - Magazine position to pick up the next tool.
TLFDn R/W R/W - (n) tool’s offset number.
TLFFn R/W R/W - (n) tool’s family code.
TLFNn R/W R/W - Nominal life assigned to tool (n).
TLFRn R/W R/W - Real life value of tool (n).
TMZTn R/W R/W - Contents of tool magazine position (n).
HTOR R/W R R Tool radius being used by the CNC to do the calculations.
TORn R/W R/W - Tool radius value of offset (n).
TOLn R/W R/W - Tool length value of offset (n).
TOIn R/W R/W - Tool radius wear of offset (n).
TOKn R/W R/W - Tool length wear of offset (n).
Variable CNC PLC DNC
( section 13.2.3 )
ORG(X-C) R R - Active zero offset on the selected axis. The value of the additive offset
indicated by the PLC is not included.
PORGF R - R Abscissa coordinate value of polar origin.
PORGS R - R Ordinate coordinate value of polar origin.
ORG(X-C)n R/W R/W R Zero offset (n) value of the selected axis.
PLCOF(X-C) R/W R/W R Value of the additive zero offset activated via PLC.
ADIOF(X-C) R R R Value for the selected axis of the zero offset with additive handwheel.
ADDORG (X-C) R R R Value of the active incremental zero offset corresponding to the selected
axis.
EXTORG R R R Value of the active absolute zero offset.
Variable CNC PLC DNC
( section 13.2.4 )
ORGROX R R R X coordinate of the new part zero with respect to home.
ORGROY R R R Y coordinate of the new part zero with respect to home.
ORGROZ R R R Z coordinate of the new part zero with respect to home.
ORGROA R R R Value assigned to parameter A.
ORGROB R R R Value assigned to parameter B.
ORGROC R R R Value assigned to parameter C.
ORGROI R R R Value assigned to parameter I.
ORGROJ R R R Value assigned to parameter J.
ORGROK R R R Value assigned to parameter K.
ORGROQ R R R Value assigned to parameter Q.
ORGROR R R R Value assigned to parameter R.
ORGROS R R R Value assigned to parameter S.
GTRATY R R R Type of G49 programmed.