·476·
Programming manual
CNC 8055
CNC 8055i
E.
·M· & ·EN· MODELS
SOFT: V02.2X
Programming assistance screens of the system.
Syntax help: Canned cycles
Page 1070 Multiple machining in a straight line: G60.
Page 1071 Multiple machining in a rectangular pattern: G61.
Page 1072 Multiple machining in a grid pattern: G62.
Page 1073 Multiple machining in a circular pattern: G63.
Page 1074 Multiple machining in an arc: G64.
Page 1075 Machining programming by means of an arc chord: G65.
Page 1076 Irregular pocket canned cycle: G66.
Page 1077 Irregular-pocket roughing: G67.
Page 1078 Irregular-pocket finishing: G68.
Page 1079 Deep hole drilling canned cycle with variable peck: G69.
Page 1080 Drilling canned cycle: G81.
Page 1081 Drilling cycle with dwell: G82.
Page 1082 Deep hole drilling cycle with constant peck: G83.
Page 1083 Tapping canned cycle: G84.
Page 1084 Reaming canned cycle: G85.
Page 1085 Boring cycle with withdrawal in G00: G86.
Page 1086 Rectangular pocket canned cycle: G87.
Page 1087 Circular pocket canned cycle: G88.
Page 1088 Boring cycle with withdrawal in G01: G89.
To Next Page
Loading...
