Fagor 8055 M - Page 62

·62·
Programming manual
CNC 8055
CNC 8055i
4.
REFERENCE SYSTEMS
·M· & ·EN· MODELS
SOFT: V02.2X
Coordinate preset and zero offsets
Only one incremental zero may be active at a time for each axis; therefore, applying an incremental
zero offset on an axis cancels the one that was active on that axis. The offsets on the rest of the
axes are not affected.
X Z
G54 (G159N1) 0 420
G55 (G159N2) 0 330
N100 G54
(It applies the first absolute zero offset)
···
(Machining of profile A1)
N200 G158 Z-90
(Apply incremental zero offset)
···
(Machining of profile A2)
N300 G55
(It applies the second absolute zero offset)
(The incremental zero offset stays active)
···
(Machining of profile A3)
N200 G158 Z-180
(It applies the second incremental zero offset)
···
(Machining of profile A4)
X Y
G54 (G159N1) 20 20
N100 G54
(Apply absolute zero offset)
N200 G158 X20 Y60
(It applies the first incremental zero offset)
N300 G158 X50 Y30
(It applies the second incremental zero offset)
N400 G158 X100
(It applies the third incremental zero offset)
N500 G158 Y0
(It applies the fourth incremental zero offset)
N600 G158 X0
(Cancel incremental zero offset)
X
Z
90 9090
150 240 330
A2A3A4
90
A1
420
G54
G158
G158
G55
G158
Y
X
80
W
50
20
20 40 70 120
W
W
W
W
M