Fagor 8055 M - Page 67

Programming manual
CNC 8055
CNC 8055i
ISO CODE PROGRAMMING
5.
·M· & ·EN· MODELS
SOFT: V02.2X
·67·
Preparatory functions
G52 * Movement until making contact 6.14
G53 * Programming with respect to machine zero 4.3
G54 * * Absolute zero offset 1 4.4.2
G55 * * Absolute zero offset 2 4.4.2
G56 * * Absolute zero offset 3 4.4.2
G57 * * Absolute zero offset 4 4.4.2
G58 * * Additive zero offset 1 4.4.2
G59 * * Additive zero offset 2 4.4.2
G60 * Multiple machining in a straight line 10.1
G61 * Multiple machining in rectangular pattern 10.2
I* * Grid pattern canned cycle 10.3
G63 * Multiple machining in a circular pattern 10.4
G64 * Multiple machining in an arc 10.5
G65 * Machining programmed with an arc-chord 10.6
G66 * Irregular pocket canned cycle 11.1 / 11.2
G67 * Irregular pocket roughing 11.1.2
G68 * Irregular pocket finishing 11.1.3
G69 * * Drilling canned cycle with variable peck 9.6
G70 * ? * Programming in inches 3.3
G71 * ? Programming in millimeters 3.3
G72 * * General and specific scaling factor 7.6
G73 * * Rotation of the coordinate system 7.7
G74 * Machine reference (home) search 4.2
G75 * Probing move until touching 12.1
G76 * Probing move while touching 12.1
G77 * * Axis coupling (slaving) 7.8.1
G77S * * Spindle synchronization 5.5
G78 * * Cancellation of axis coupling (slaving) 7.8.2
G78S * * Cancellation of spindle synchronization 5.5
G79 Canned cycle parameter modification 9.2.1
G80 * * Canned cycle cancellation 9.3
G81 * * Drilling canned cycle 9.7
G82 * * Drilling canned cycle with dwell 9.8
G83 * * Deep-hole drilling canned cycle with constant peck 9.9
G84 * * Tapping canned cycle 9.10
G85 * * Reaming canned cycle 9.11
G86 * * Boring canned cycle with withdrawal in G00 9.12
G87 * * Rectangular pocket canned cycle. 9.13
G88 * * Circular pocket canned cycle 9.14
G89 * * Boring canned cycle with withdrawal in G01 9.15
G90 * ? Absolute programming: 3.4
G91 * ? * Incremental programming 3.4
G92 Coordinate preset / spindle speed limit 4.4.1
G93 Polar origin preset 4.5
G94 * ? Feedrate in millimeters (inches) per minute 5.2.1
G95 * ? * Feedrate in millimeters (inches) per revolution. 5.2.2
G96 * * Constant cutting point speed 5.2.3
G97 * * Constant tool center speed 5.2.4
G98 * * Withdrawal to the starting plane at the end of the canned cycle 9.5
G99 * * Withdrawal to the reference plane at the end of the canned cycle 9.5
G145 * * Temporary cancellation of tangential control 6.17
Function M D V Meaning Section