TROUBLESHOOTING
In the event of any fault:
• turn o the appliance,
• disconnect the power supply,
• based on the instructions given in the table below, some minor issues can be corrected
by the user. Please check the consecutive points in the table before you refer the repair to
customer service.
Problem Reason Remedy
1. The appliance does not
work
No power Check the fuse, replace if
blown
2. Oven lighting does not
work.
Loose or damaged bulb Replace the blown bulb (see
Cleaning and Maintenance sec-
tion)
3. The programmer display
shows “0:00”.
The appliance was discon-
nected from the mains or
there was a temporary
power cut.
Set the current time
(see ‘Use of the programmer’)
4. Fan does not work Risk of overheating! Immediately unplug the appliance or
switch o the main circuit breaker. Refer the repair to the
nearest service centre.
If the problem is not solved, disconnect the power supply and report the fault.
Important! All repairs must be performed by qualied service technicians.
64
To Next Page
Loading...
