Fagor 8H-875TCB - Timed operation; Delayed timed operation; Using pre-set programmes

OPERATION
but you can set the oven to turn o using timed
operation function of delayed timed operation
function. The only exception is the pyrolytic
cleaning function, which cannot be modied.
Timed operation
In this mode the oven will turn o after a set
duration. You can set the duration from 1 min-
ute to 10 hours. To set timed operation for any
oven function, touch and hold the sensor,
and the timer symbol ashes in the display.
Touch the sensor again, the display will
show the symbol. Now you can:
Use to set the duration and touch to
conrm.
Use and to adjust the time settings.
Touch to conrm the adjusted setting.
To cancel timed operation use to adjust
duration down to and touch to
conrm.
Timed operation will interrupt the active oven
function. When the set Duration has elapsed,
you will hear beeping. Touch any sensor
except to mute the beeping. When the
beeping is muted the appliance enters the
operation mode.
Note: When you use the sensor to mute the
beeping, the appliance will allow you to adjust
the Duration time.
Delayed timed operation
You can set the oven to start at a specic time
and operate for a set Duration. You can delay
the oven start from 1 minute to 10 hours, and
set the Duration for up to 10 hours. To activate
the delayed timed operation, rst set the timed
operation. Then touch and hold the sensor
again and the timer symbol will ash on
the display. Touch the sensor twice, and
the pictogram will ash on the display.
Now you can:
Use to set the time for the oven to turn o
and then touch to conrm.
Correct the oven on time with the sensors
and . Touch to conrm the adjusted
setting.
To cancel timed operation use to adjust
duration down to the lowest possible value
and touch to conrm.
Timed operation will interrupt the active oven
function. When the set time has elapsed, you
will hear beeping. Touch any sensor to mute
the beeping. When the beeping is muted the
appliance enters the operation mode.
Pre-set programmes
These are programmes with specic settings
of function, temperature and duration that are
most suitable for a given dish. When the ap-
pliance is on, touch to access the pre-set
programmes menu – the pre-set programme
“P01” will be shown on the display. Use the
and sensors to select the pre-set pro-
gramme from the table below. Then touch
to conrm your selection and the appliance
will start to operate.
51