22/07/2019
23
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
8.4.3. DETERGENT ELECTRIC DISPENSER CONNECTION (ADVANCE model, optional in
CONCEPT and CONCEPT PLUS)
ONLY use liquid detergents which are not foam-forming at high temperatures and which are of commercial
quality. Please contact a qualified chemical product supplier.
INSTALLATION
If the detergent dispenser is not pre-installed in the appliance, an installation kit can be ordered from your supplier
or manufacturer.
The tub has an opening for the installation of a detergent intake bushing in the appliance. This is marked with the
label “DETERGENT CONNECTION” and is located on the front of the wash tank, above the maximum water level.
The existing plug should be removed and the bushing inserted in the hole. The detergent dispenser is installed in
the lower front of the appliance and is connected electrically using the existing connection and marking it to this
effect.
After installing the detergent dispenser or if this has already been pre-installed at the factory, the end of the clear
tube with filter at the rear of the machine marked «Detergent» should be inserted in the detergent container.
The tubes are see-through to allow you to check that the chemicals are correctly dispensed.
To access the dispensers and adjust them, remove the lower front cover of the appliance.
OPERATION
This dispenser absorbs and dispenses detergent when the rinse pump is switched on. That is, when the machine is
filling and during the rinse cycle.
LOADING PROCESS
When the appliance is switched on, the loading process takes place automatically while the machine is filling.
ADJUSTING THE DOSE
The dispenser should be adjusted when the machine is installed to ensure that the wash is optimised from the
start. The setting should be adjusted according to the type of rinse aid and the water hardness. Turn the
adjustment screw until the required dose is obtained (turn clockwise to increase and anticlockwise to reduce the
dose).
connection
(rear section)
tank
To Next Page
Loading...
