22/07/2019
42
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
3 Drainage error: If PT=0 (tank full) for 1.30 minutes, and BD=1 (draining): This is indicated by a three-
impulse train
4 Boiler heating error. This is indicated by a four-impulse train.
a. If DIP4=0 (no Clinic Line): If PT=0 (Tank full) and TC=1 (boiler temperature not reached) for 35
minutes.
b. If DIP4=1 (Clinic Line): If TT=0 (in fact it refers to PB) (Tank full) and TC=1 (boiler temperature not
reached) for 35 minutes.
5 Tank heating error: If DIP4=0, PT=0 (Tank full) and TT=0 (tank temperature not reached) for 90 minutes
and MBL=V=0 (Wash pump motor stopped and without entering water): This is indicated by a five-impulse
train.
6 Boiler fill error: While DIP4=1, if Vreg is on for 5 minutes and the boiler level is not reached (TT=1). This is
indicated by a six-impulse train.
9.6. ADVANCE OPERATION
The wash cycle of the machine includes a wash, drainage and a final rinse.
The tank thermostat maintains the wash water temperature and a motor pump sends this water with detergent to
the washing arms. The jets of water reach the dishes from different directions in order to guarantee a uniform
wash.
Between the wash cycle and the rinse cycle there is a pause of a few seconds to allow the detergent to drain off the
dishes into the wash tub. If the machine has a drainage pump, part of the water is drained from the tank and
replaced by clean rinsing water.
Lastly, the dishes are rinsed with mains water heated to between 80 ºC - 85 ºC / 176 ºF - 185⁰F to remove the
detergent from the dishes and at the same time regenerate the water in the wash tank, making it less dirty.
By default, the ADVANCE model always starts with the P1 cycle selected. To change the wash cycle P1, P2 or P3
press the MENU button and the selected cycle and its length will be displayed in the DISPLAY. Once the wash cycle
has been selected, insert the basket with the dishes and close the hood. The START, button changes from green to
blue at the start of the wash cycle and flashes during the rinse cycle.
The wash and rinse temperatures are briefly shown in the DISPLAY at the start of the cycles. In the lower band of
the display, a decreasing bar indicates the percentage of the cycle remaining (if the cycle is extended by the
TERMOSTOP or a regeneration, the bar stops until the rinse has been completed).
At the end of the wash cycle, the START button changes to red and the DISPLAY advises that the cycle has ended.
When the hood is opened, the message disappears and the START button changes to green.
The cycle selected will remain selected until the selection is changed or the appliance is switched off.
The hood should not be opened while the machine is running, but if it is opened, the cycle will pause, and resume
when the hood is closed again.
RED: Machine getting ready (filling and/or heating).
GREEN: Machine ready
BLUE: Cycle running
In models with EFFI-RINSE SYSTEM (CONCEPT PLUS and ADVANCE) the RINSE led pilot light lights
up when a rinse is run at temperatures which guarantee the correct sanitisation in accordance with health
regulations, and at a constant rinse pressure.
When the wash cycle ends, open the door and remove the basket, allowing the dishes to dry by evaporation for a
To Next Page
Loading...
