22/07/2019
53
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
In all the wash programmes P1, P2, P3 and PGLASS, when the user presses START/STOP with the door closed the
programme is run. If during the programme, the user presses START/STOP, again, the programme will end without
rinsing.
On the other hand, if during the wash programme the user opens the door, a PAUSE is made.
If during a wash cycle P1, P2, P3 or PGLASS a short regeneration is made, the rinse is not carried out until the
regeneration programme has ended, therefore the control will wait in wash phase. On completion of the
regeneration programme, the control will end the wash programme, moving to the drain and rinse cycles.
If during the wash phase, the boiler does not reach the maximum level or rinse temperature (programmable
parameter) the control will wait in the wash phase until this is reached (thermostop function). If after 8 minutes of
washing the boiler has not reached the required level or rinse temperature, the control switches to the drain and
rinse mode, displaying the warning “A4-Low rinse temperature” (if this is 10 ºC below the set temperature).
VC is cancelled during the rinse. On completion of the rinse, the programme displays “END WASH” and the control
activates VC to send water to the boiler. VC remains active until the level PC≥Pc-HIGH is reached, even if the door
is opened (no pause is made).
9.6.14. MANUAL /AUTOMATIC, DRAINAGE
ADVANCE models are fitted with a drainage pump as standard.
There are several ways to drain the tank:
Automatic drainage
5 minutes after switching off the machine, the wash tub is automatically drained, unless a Manual Drainage or Self-
cleaning cycle are run first.
Manual drainage
WASHING PROGRAMMES: P1, P2, P3, P4
To Next Page
Loading...
