When TG<80 ºC, when CV operates, and in
10 minutes, TG does not rise 3 or more
degrees.
Only the Convection mode will be
available.
CC operates and in 25 minutes, TC does not
rise 3 or more degrees (If TC<(set temp -10).
The oven will be deactivated completely.
The NTC of the controller reaches 60 ºC, but
does not exceed 70 ºC.
The oven works normally and the alarm
does not go off. This message is
displayed for 3 seconds every 30 minutes.
E13: QC
BLOWING FAN
(Only GAS ovens)
Chamber blowing fan error
The oven will be deactivated completely.
E14: QC
BLOWING FAN
LOCKING (Only
GAS ovens)
Chamber ignition control locked. This error is
generated when the chamber burner does
not ignite after 3 tries
The oven will be deactivated completely.
E15: QC FAULT
(Only GAS ovens)
Ignition box fault caused by one of these 2
errors:
EV gas does not activate / The box cannot
be unlocked
The oven will be deactivated completely.
E16: QV
BLOWING FAN
FAULT (Only GAS
ovens)
Only the Convection mode will be
available.
E17: QV
LOCKING (Only
GAS ovens)
Steam ignition control locked. This error is
generated when the chamber burner does
not ignite after 3 tries.
Only the Convection mode will be
available.
E18: QV FAULT
(Only GAS ovens)
Boiler ignition box fault caused by one of
these 2 errors:
EV gas does not activate / The box cannot
be unlocked.
Only the Convection mode will be
available.
The controller’s NTC exceeds 70 ºC
The oven will be deactivated completely.
Communication error. The chamber’s card
does not respond.
The oven will be deactivated completely.
Communication error. The control panel’s
card does not respond.
The oven will be deactivated completely.
Communication error. The boiler’s card does
not respond.
Only the Convection mode will be
available.
E27: GAS
Connection (Only
GAS ovens)
Communication error. The gas card does not
respond.
The oven will be deactivated completely.