SERVICE MANUAL
ADVANCE OVENS
04/02/2020 110
M3 H Prg Regen - Total hours of operation in Regeneration mode.
M4 H Prg CtrlSt -
Total hours of operation in Controlled Steam mode.
M5 H Prg Steam - Total hours of operation in Steam mode.
M6 CC1 Cycles -
Number of CC1 cycles.
M7 CC2 Cycles -
Number of CC2 cycles.
M8 CV1 Cycles - Number of CV1 cycles.
M9 CV2 Cycles -
Number of CV2 cycles.
M10 VDV Cycles -
Number of VDV cycles.
M11 VDCN Cycles -
Number of VCN cycles.
M12 Ms/Mb Cycles-
Number of Ms/Mb cycles.
M13 VHM Cycles -
Number of VHM cycles.
M14 LZ Cycles -
Number of LZ cycles.
M15 VE Cycles -
Number of VE cycles.
M16 RG Cycles -
Number of RG cycles.
M17 R/L Cycles -
Number of R/L cycles.
M18 M/P Cycles- Number of M/P cycles.
M19 IP Cycles -
Number of IP cycles.
M20 CD Cycles -
Number of Cool down cycles.
M21 Calibrat. No - No of calibrations.
M22 Descale Cycles -
Number of descale cycles.
M23 H Prg Rel-1 -
Hours of programme Reliability 1.
M24 H Prg Rel-2 -
Hours of programme Reliability 2.
M25 H Prg Rel-3 -
Hours of programme Reliability 3.
M26Prg Rel-4 - Hours of programme Reliability 4.
M27 H Prg Rel-5 - Hours of programme Reliability 5 (not used).
M28 TC Max -
Maximum temperature of TC.
M29 TV Max -
Maximum temperature of TV.
M30 TN Max -
Maximum temperature of TN.
M31 TG Max- Maximum temperature of TG after last descaling.
M32 No of Errors -
Total number of errors.
M33 End Log -
End Log.
The total number of errors in the oven can never be deleted.
M41 Exhibition Option allowing the oven to be set in Exhibition mode. To start, press the button on the
wheel. When the oven is operating in exhibition mode, only the Interface and the RG and LZ, outputs should
operate, all other inputs/outputs are disabled and all errors are ignored.
M42 Exit Option for exiting the menu and returning to oven normal operating mode. To do so, press the
button on the wheel.
When an error occurs:
• The bell rings intermittently.
• A flashing message is shown on the upper text of the display.
• If the START/STOP button is pressed or the door is opened, the error message continues to be displayed
but the bell stops ringing.
• To reset the error, switch off the oven.
• When the fault causing the error is removed, the outputs return to normal operation.
To Next Page
Loading...
